Liked the looks of this sink set up.Read the other reviews. They are helpful too.Supply lines are 1/2" FIP not 3/8" ....so I had to get 1/2" x 1/2" couplingsand very short 1/2" X 3/8" compression braided faucet lines to connect to the shut off valves..I had searched for replacement shutoff valves but could not find any 1/2" FIP discharge for the supplied lines the faucet came with.Don't know why the supply lines are not 3/8" compression like the most are provided. Guess it depends where they are made and ..The next issue I came across was that this set up comes with a Vent in the drain line.After drilling a hole in the top of the cabinet I was converting into a vanity (which was solid wood top and then a second piece on bottom which was compressed wood) and connecting the drain line with the supplied material I was still having draining issues.I ended up drilling a hole large enough so the drain nut and gasket would tighten up against the bottom of the bowl itself!If your top is stone or some other solid material I don't know if the seal will be okay?.The bowl did not sit flat on the top of the cabinet. When you caulk the bottom to the top it can be leveled at this time.Just put enough caulk to set the bowl then run a bead around the edge to clean up the lines..I will have to see after several months of usage to report on how well this set up holds out.The supplied faucet is a much thinner metal and could dent very easy. But for the cost I figured I would give it a try.